Skip to content
Green flake floor in a commercial building with a glass roll-up door

Moisture vapor barrier coatings

A vapor barrier coating is a primer layer that limits moisture moving up through the slab, so the floor above can stay bonded.

What a moisture vapor barrier is

Concrete is porous, and moisture from the ground or from the original pour can move up through a slab as vapor.

When that vapor is trapped under a coating or flooring, it can cause blisters, peeling or adhesive failure.

A moisture vapor barrier, sometimes called a moisture mitigation system, is a specially formulated epoxy layer applied directly to the slab. It limits vapor transmission so the coating or flooring on top can bond and stay bonded.

How it is installed

It starts with testing.

New slabs, slabs without a vapor barrier underneath, and floors with a history of failures are tested so the right approach can be chosen.

The slab is ground to open its surface, cracks are treated, and the barrier is applied at the coverage the product calls for. The finished coating system or flooring is then installed on top.

  • Moisture testing of the slab
  • Grinding to open the surface
  • Crack treatment
  • Apply mitigation layer
  • Install the coating or flooring above

Key properties

The barrier's job is to stay bonded under vapor pressure and slow the moisture enough for the system above to perform.

It is a hidden layer; the look of the floor comes from what goes on top.

It adds material and time to a project, so it is used where testing shows it is needed, not by default.

Where it is used

Mitigation is common on newer slabs, buildings on wet sites, slabs poured without a below-slab vapor barrier, and floors that have already failed from moisture.

Strengths, limits and when to choose something else

A barrier can save a floor that would otherwise blister, and it makes a coating possible on slabs that would not accept one.

It cannot fix active leaks, standing water or drainage problems, which need to be solved at the source.

On slabs that test low, a standard primer is usually enough, and urethane cement may be an option where its own moisture tolerance fits the conditions.

Care and maintenance

  • The barrier itself needs no care once it is covered.

  • The finished floor above is maintained according to its own system.

  • Keep exterior drainage, irrigation and gutters directing water away from the building, since conditions outside affect how much moisture reaches the slab.

At a glance

PropertyWhat to expect
PurposeLimits vapor moving up through the slab
PositionDirectly on the slab, under the finished floor
When neededDecided by moisture testing
LookHidden under the final system
Not a fix forLeaks, standing water or drainage issues
UpkeepNone once covered

FAQ

Moisture vapor barrier: questions

Straight answers to the questions we hear most.

How do I know if my slab has a moisture problem?

Testing is the only reliable way. Signs like blisters, peeling coatings, white powder or adhesive that has turned soft point to moisture, but tests show how much and decide the fix.

Why would a new building need moisture mitigation?

New concrete holds a lot of water from the pour, and some slabs are placed without a vapor barrier underneath. Coating too soon or without mitigation is a common cause of early failures.

Can a vapor barrier go under tile, carpet or vinyl too?

Many mitigation systems are designed to sit under several kinds of flooring, not just coatings. The product and the finished floor have to be compatible.

Is moisture mitigation always needed before coating?

No. Many slabs test fine and only need standard prep and primer. Mitigation is added when the results call for it.

Ready for a bid?

Send the details or plans for a written bid.

Request a Bid
Crew finishing a glossy light grey coating across an aircraft hangar floor

Request a bid

Ready for a bid?

Send your project details or plans. We reply within 1 business day.