A garage floor that leaves grit on everything, or is flaking away at the surface, is usually wearing from the top down. Whether it can be repaired and coated or needs more work depends on how deep the damage goes.
These are three stages of surface wear. Dusting is a powdery layer that comes back however often you sweep. Scaling is the top layer flaking off in thin patches, and spalling is deeper chips and pits breaking out of the slab.
Dusting: fine grit that keeps returning after sweeping
Scaling: thin flakes of the surface peeling away
Spalling: chips and pits where pieces have broken out
Why garage concrete wears this way
Bare concrete soaks up water. In a Utah winter, salty slush drips off cars, soaks into the surface and freezes, and each freeze-thaw cycle breaks a little more of the top layer loose. The damage is usually worst near the door and under where cars park.
Some slabs also had a weak top layer from the start, from the way they were finished or cured, so they dust even without salt.
Surface damage like this is repaired as part of coating prep. The slab is diamond ground under vacuum dust extraction, which removes the weak, dusty top layer, and pits, spalls and cracks are repaired before the moisture primer goes down.
Once coated, the floor is a sealed, non-porous surface. Salty water sits on top instead of soaking into the concrete, which is what drives freeze-thaw damage on bare slabs.
If large areas have broken up, the slab is heaving or sinking, or the damage goes deep, the concrete may need repair or resurfacing first. A coating protects a sound slab but cannot hold together one that is falling apart.
That is why we check the concrete on the estimate, before anything is quoted.
Do I need new concrete if my garage floor is crumbling?
Usually not. Surface dusting, scaling and spalling are repaired during prep, with diamond grinding and crack and pit repair, and the slab is then coated. A slab that is breaking apart or still moving may need more first, and we check it on the estimate.
Will sealing stop a dusty garage floor?
It can reduce it. A sealer can cut down dusting on bare concrete, while a coating covers the surface completely after the slab has been diamond ground and repaired. Which one suits a particular floor depends on its condition and how it is used.
Why is the damage worst near the garage door?
That is where salty slush drips off cars and where the slab freezes and thaws most often, so water and salt work into the surface there first.
How long does a garage floor repair and coating take?
Most garages are done in a single day. Floors with significant pitting or spalling to repair may run two to three days, which the estimate flags ahead of time.